- Protective case
- Airtight, waterproof and dustproof
- Shock resistant and corrosion resistant
- Chemical and UV resistant
Pay over time for orders over $300 with Affirm.
Seahorse SE720 Waterproof Protective Case (Orange)
Seahorse Protective Cases keeps your valuable equipment safe. Close and latch your Seahorse cases to automatically safely seal your gear against water, air and dust. Its tough with Acuform foam or dividers will keep your camera, video or high cost equipment safe from impact, providing safe, secure protection from the elements. Built-in padlock holes give extra safety. Seahorse optional locking latches give added security and keeps out prying hands.
Automatic Pressure Purge System
Seahorse's Automatic Pressure Purge System guarantees a perfect seal by incorporating its own O-Ring under one of the latches. You will never forget to set the valve since it automatically activates when closing the case. Pressure is released as you open the latch.
Molded-In Padlock Holes
Each case has two molded-in padlock holes to secure your valuables. The padlock holes will accept TSA and most standard padlocks.
Optional multilayer protective pre-scored cubed foam. Accuform Foam in Seahorse cases consists of a layer of egg crate foam in the lid, a thick cubed foam center layer, and a 1/2 inch thick high density shock absorbing foam bottom layer.
Padded Divider Sets
Optional (Available only with the SE-520, SE-720, SE-920, and SE-1220). Seahorse's Padded Divider sets consists of thickly padded, lined divider walls that are adjustable to an infinite variety of configurations, allowing you to provide various sized compartments to protect your valuable equipment.
Waterproof Panel Kit
The Seahorse Panel Kits are used when specific equipment needs to be kept protected even when the case is open. These two plates are made of .063 inch brushed aluminum and include screws, one perimeter gasket and O-Rings for the screws to waterproof the bottom portion of your case.
Available with latches with keyed chrome metal locks or plastic non-corrosive locks. Metal locks are made entirely of chromed steel and keyed. Plastics locks are molded of ABS Resin, one of the toughest co-polymers available. Keys are also made of Plastic.