BLUESHAPE 10.24 x 3.35-Inch 3-Stud 6A Travel Charger with Carrying Handle and Simultaneous Charge
Product highlights:
- 10.24 x 5.91 x 3.35-Inch 3-Stud 6A Travel Charger
- Up to 2 installable batteries
- Retractable Foot design
- On/Off switchable fan
- DC-UPS-Uninterrupted AUX power
- Comes with Data socket, Battery bay #1 and #2
- Features Auxiliary power XLR 4pin, Exhaust Ventilation
- Features Mains socket with fuse
- Features Battery release button and Carrying handle
- LEDs (Bat #1, AC on/off, Bat #2)
In the box
BLUESHAPE 10.24 x 3.35-Inch 3-Stud 6A Travel Charger with Carrying Handle and Simultaneous Charge
- BLUESHAPE 10.24 x 3.35-Inch 3-Stud 6A Travel Charger with Carrying Handle and Simultaneous Charge
- Limited 18-Month Warranty
BLUESHAPE 10.24 x 3.35-Inch 3-Stud 6A Travel Charger with Carrying Handle and Simultaneous Charge
The BLUESHAPE 3-Stud 6A Travel Charger is an intelligent lithium-ion battery chargers have been specifically designed and optimized for fast, safe, and reliable charging of BLUESHAPE batteries. The charging speed depends on the type of batteries on charge since the charger communicates and acquires information from the batteries during operation. The CGTR2P is capable of delivering up to a maximum of 6 Amps in constant current (CC) mode on both channels simultaneously. This makes it ideal for fast turnaround, especially when using higher-capacity batteries. However, when charging smaller batteries, the charger never exceeds currents higher than 0.5C to avoid overheating and stress to the Lithium Ion cells. Nevertheless, these chargers can also charge third-party, non-communicative batteries but at a fixed rate. A precaution is included by design in order not to overcharge third-party batteries or render them unsafe. For the users’ convenience, the external dimensions have been kept as compact as possible for better portability.
Charging
The electronic circuitry provides a very accurate lithium ion charge algorithm. Initially, the chargers will only apply a pre-charge current of a few mA to batteries that are heavily discharged. Once the cells inside the batteries reach a safe level, the full (maximum) charging current is delivered at a maximum rate of 6A (but less than 0.5C) until the batteries reach almost 90 percent state of charge (SOC). This charging rate is only applied when the fan is set to ON. If the fan is switched to OFF for silent operation, the charging current is reduced to not exceed 3.5A (but less than 0.5C - see table). After the constant current (CC) phase is completed, a constant voltage (CV) phase initiates with the current tapering slowly to 150mA until full cut-off.