Product highlights:
- The Alpha·Omega 500 is a 500W amplifier equipped
- An all-analog preamplifier, two distinct distortion circuits (Alpha and Omega)
- A custom-designed Darkglass high-efficiency class D Module
- An ultra-quiet graphic equalizer, and a digital impulse-response cabinet emulator for DI outputs or headphones
- The USB connector allows you to use the Darkglass Suite to load different cabinet impulses or change different parameters on your amp
Darkglass Electronics AO500 Alpha-Omega 500W Bass Amplifier Head
The Darkglass Alpha·Omega 500 is a 500W amplifier equipped with an all-analog preamplifier, two distinct distortion circuits (Alpha and Omega), a custom-designed Darkglass high-efficiency class D Module, an ultra-quiet graphic equalizer, and a digital impulse-response cabinet emulator for DI outputs or headphones.
Input
Use this jack to connect your instrument via a standard ¼ inch mono cable.
Passive/Active
Use this push-button switch to change from passive to active mode. If your bass is active it can have a hotter signal making the amp distort early (feel free to use it if such additional distortion is desired).
Distortion
Use this push button to turn on or off the Alpha·Omega Engine to add natural compression, organic harmonic enhancement, and saturation ranging from mild overdrive to high gain bass range. The Alpha·Omega Engine operates before the clean section (you can therefore use the 6-Band Active EQ for additional tone shaping).
Bite
Boosts high mids (2.8kHz) for additional presence and definition.
Growl
Shelving Bass Boost for a fatter tone and increased low-end saturation.
Compression
This knob controls the amount of dynamic compression added to the Alpha·Omega Engine. The makeup gain is adjusted automatically. The compression can be turned off or assigned using the Darkglass Suite.
Speaker Output
Use this connector to connect the amplifier to your cabinet. This Speakon combo jack allows for either Speakon or ¼ inch speaker cable operation.
Send
Use this output to send the signal to effects pedals.
Return
Use this input to receive the signal from effects pedals. Master volume control is after this input.
Ground Lift
Use this control to lift the ground of the DI XLR output. If you are experiencing ground noise in your DI signal try changing the setting of this control.
DI Output
Use this connector to send your signal to the console, mic preamp, interface, etc. Both signals are available (The bypass and the amp signal with cabinet simulation) and are switched from the cab select switch.
USB
The USB connector allows you to use the Darkglass Suite to load different cabinet impulses or change different parameters on your amp.