Darkglass Alpha Omega Ultra V2 with Aux Input

Darkglass Alpha Omega Ultra V2 with Aux Input

The Darkglass Alpha Omega Ultra V2 with Aux Input is the most versatile bass preamplifier. Its two distinct distortion circuits (Alpha and Omega), extremely high dynamic range, six-band active graphic EQ, dedicated headphone output, and balanced direct output with switchable digital impulse-response cabinet emulation make for an incredibly complete tool for the modern bass player.

Blend

Blend control mixes the clean and processed signals. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine mix tuning.

Level

This sets the volume of the overdriven signal.

Drive

This sets the amount of gain in the overdriven signal.

Bite

Bite boosts High Mids (2.8kHz) for additional presence and definition.

Growl

Shelving Bass Boost for a fatter tone and increased low-end saturation.

Mod

Mod selects or mixes between the two distinct distortion circuits: Alpha is punchy, and tight with a lot of definition, whereas Omega is simply brutal and raw. On the Darkglass Suite, you can assign footswitch control of the Mod toggle between Alpha and Omega.

Master

Whereas the Level knob controls the output of the overdrive section the Master volume adjusts the overall volume of the unit. Ideal for fine-tuning the output in clean mode. It also serves as a DI and headphone volume control. Please note that volume is not affected by this control when the pedal is on bypass.

Ground Lift

This disconnects the signal ground on the Direct Output to break any ground loops. Set this switch to either position that has less noise. The switch does not affect the 1/4-inch output.

Cab Sim

Toggle the cabinet simulation on/off on the Direct Output. This switch completely bypasses all digital circuits and allows you to get a zero-latency signal when needed.

Headphones

Alpha Omega Ultra has an internal stereo headphone amplifier capable of driving a minimum load of 16 ohms from the 3.5mm stereo jack. Use the Master volume control to adjust the level.

USB

A Micro USB B connector allows you to connect the pedal to a PC/Mac to load cabinet simulation impulse responses to the pedal and control various other settings.

Aux In

This 3.5mm stereo input allows you to practice with backing tracks from e.g. your smartphone or laptop. Auxiliary input can only be used with the headphone output. The pedal does not control the level, it must be set from your audio source. Remember to always first set the level low before connecting anything to the aux in.

*Note: When the pedal is on bypass the master volume does not affect the headphone volume. In this case, the total volume is adjustable in Darkglass Suite. With sensitive headphones, the bypass volume can be very loud if not adjusted. The Alpha Omega Ultra has a current draw of 130mA. Only use a regulated 9V DC adapter with a center-negative plug. Due to ecological reasons, it does not accept batteries. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty